Valve Block solenoid fault Diagnosis. Common fault with Land Rover air suspension valve solenoids is they stop distributing the air pressure to the individual air struts controlled by the air suspension system or you may get a corner of the vehicle sinking down overnight ,their are usually 3 solenoid valve blocks ! 2 airbag/strut solenoidsI went ahead and wired in the Atlantic British EAS reflash module 7980 on my 2008 LR3 with the emu lift kit. The warning light is now extinguished, but still get "suspension fault max speed 30 MPH" on the display, however the +bloody chimes+ are thankfully gone. Suspect disconnecting the ride height sensors will get rid of the display warning.
Plugging in the IID tool revealed the following errors: P006A-00 (27) Manifold absolute pressure - mass or volume air flow correlation, P00BD-07 (27) Mass or volume air flow A circuit range/performance - Air flow too high - General failure information - mechanical failure, P1247-00 (27) Turbocharger boost pressure low, and. P0235-94 (27
9. 95rrclwb Discussion starter. 43 posts ยท Joined 2014. #1 ยท May 26, 2016. Took the truck on a light duty fire road last night and had a suspension fault light illuminate and the front suspension now raises very slowly. Before going off road the front and rear suspension raised very quickly. The pump runs for as long as the front suspension
My 2006 Range Rover Vogue SE has a fault, when I am driving along towing my car trailer with my TVR Race car on the back, after 10 to 15 miles a warning light and bleep comes on, it says there is a HDC fault and then the suspension lowers it's self down. I stop turn things off and it resets it's self and then it happens again 10 to 15 miles later.
KOC8SmE.